Ownership Guide
Which coin battery your Toyota key takes, how to change it with a small screwdriver, and how to unlock and start the car if the fob has already died.
Most Toyota key fobs run on a 3-volt lithium coin battery. Smart keys for push-button start usually take a CR2032, the larger smart key on newer models takes a CR2450, and keys with built-in lock and unlock buttons usually take a CR2016. Changing it takes a few minutes with a small flathead screwdriver, and the key normally keeps its pairing, so there is nothing to reprogram.
Last reviewed: November 2026. Battery types and steps come from Toyota owner’s manuals. Key designs change by model and year, so confirm the battery number stamped on your old battery or on the “Electronic key battery” page of your owner’s manual before you buy.
The number is stamped on the battery itself. These are the types Toyota lists in the owner’s manuals and owner pages we checked:
| Key style | Battery | Toyota lists it for |
|---|---|---|
| Smart key, newer larger design (push-button start) | CR2450 | 2021 Venza, 2024-and-newer Tacoma, 2025 Tundra |
| Smart key, earlier design (push-button start) | CR2032 | Camry, including the 2012 Camry with smart key |
| Key with built-in lock and unlock buttons (turn-key ignition) | CR2016 | 2012 Camry without smart key; Tundra wireless remote |
| Some older smart keys | CR1632 | Earlier Prius Plug-in |
The numbers describe the size. A CR2032 is 20 mm across and 3.2 mm thick, and a CR2450 is 24.5 mm across and 5.0 mm thick, so one will not fit in place of the other. Toyota’s manuals say to replace the battery only with the same type.
You need a small flathead screwdriver, a rag and the new battery. Work with dry hands.
If the cover will not close firmly, Toyota’s manual says to stop using the key and contact a dealer.
On a key with the lock and unlock buttons built into the head, the battery sits in a small module inside the case.
Toyota’s manuals describe two signs: the remote’s range shrinks, and the smart key system or the lock and unlock buttons stop working reliably. If you have to stand closer to the car than you used to, or press a button more than once, change the battery before it quits.
A dead key battery does not strand you. These steps are from the 2024 Highlander Hybrid owner’s manual and work the same way on most push-button-start Toyotas.
Toyota calls this a temporary measure. Replace the battery as soon as you can. Note that locking the doors with the mechanical key does not set the alarm.
Coin batteries are dangerous if swallowed. Toyota’s manual warns that a swallowed battery can cause chemical burns in about two hours and calls for emergency medical care. Keep new and used batteries away from children, and do not leave a key with a loose cover where a child can reach it.
Not sure which battery your key takes, or the cover will not come off? Stop by our parts or service counter in Enfield with the key and we will take a look.
Related
Common Questions
Most Toyota key fobs take a 3-volt lithium coin battery. In the Toyota owner’s manuals we checked, smart keys use a CR2032 or, on the newer larger design, a CR2450, and keys with built-in buttons use a CR2016. The number is stamped on the old battery and listed in your owner’s manual.
The Camry smart keys in the Toyota manuals we checked use a CR2032, and the 2012 Camry key with built-in buttons uses a CR2016. The 2025-and-newer Camry key is a different design, so read the number on the old battery before you buy.
Toyota lists a CR2450 for the smart key on the 2024-and-newer Tacoma and the 2025 Tundra. An earlier Tundra manual lists a CR2016 for the wireless remote. Check the old battery, because key designs changed between generations.
Normally no. The key keeps its pairing with the vehicle when the battery is swapped. If the key does not work with a fresh battery installed the right way up, have the key and the vehicle checked.
Yes, on push-button-start models. Press the brake, touch the Toyota emblem side of the key to the start button until a buzzer sounds, then press the start button. Use the mechanical key inside the fob to unlock the door first.
No. All three are 3-volt lithium coin batteries, but they are different sizes. A CR2032 is 20 mm by 3.2 mm, a CR2016 is 20 mm by 1.6 mm, and a CR2450 is 24.5 mm by 5.0 mm. Toyota’s manuals say to use only the type your key was built for.
Toyota’s manuals say the battery is available at Toyota dealers and at stores that sell electronics or camera batteries. Bring the old battery or the key so you can match the number.
If a new battery does not fix it, bring the key and the vehicle to our service center in Enfield, CT and we will check the key and the smart key system.